Clipsal C-Bus Manuale delle Istruzioni Scaricare il pdf (Pagina 99)

1250SM0904R10/09 C-Bus™ Basic Programming

10/2009 C-Bus™ Products Training Course

 firmware version of the C-Bus device

 serial number of the unit

 catalogue number of the unit.

The table below highlights the more important parameters in the Unit

Identification tab.

Parameter Description

Part Name Assigns a name to the C-Bus unit, to help identify its physical location.

This is an 8 character name which is physically stored in the relay.

Application Selects the application address that the relay will operate on.

Area Specifies an area address for all relay channels to respond to.

Tag Name Assigns a more meaningful name to the C-Bus relay. This is only stored

in the C-Bus database.

Notes Documents any nonstandard information about the programming,

installation or application the C-Bus relay. This is only stored in the

C-Bus database.

Table C 1 - Important parameters on the Unit Identification tab

NOTE: The Unit Identification tab is common and identical for almost all

C-Bus units.

Logic Tab

The Logic tab is separated into two parts:

 Logic Assignments

 Logic Recovery.

The Logic Assignments allows you to configure 4 low level AND/OR

operations on the relay. This means that the control of the selected

channels will be dependant on the state (ON or OFF) of the associated logic

group.

The Logic Recovery will determine the behavior of the logic group. Logic

Recovery will affect the state (ON or OFF) that the Logic Group will return to

after power up, allowing the selection of:

 N/C (No Change, which restores to its previous level)

 OFF

 A Level (1% to 99% which is technically ON when using a relay)

 ON.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 147 148

Nessun commento

Clipsal C-Bus Manuale delle Istruzioni Pagina 99